Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
3
Installing the drain
□
Install main plunger (E), rubber washer (F) and
drain body (H) above the sink.
□
From below the sink, install the lock nut (G).
E
F
G
H
Operation
1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
aerator to flush the water lines. Do not lose the gasket in
the aerator.
□
Ensuring the handles are in the off position, turn
on the water supply and check for leaks. If you
discover any leaks, check your connections to
ensure they are installed properly.
□
Use aerator wrench (D) to remove the aerator
(B) from the faucet (A). Turn on the hot and cold
handles to allow the water to run for at least one
minute. This flushes away any debris that could
cause damage to internal parts.
□
Turn off the water and reinstall the aerator (B) and
housing (if applicable).
4
Making the water supply
connections
□
Use two adjustable wrenches to connect and
tighten the supply lines to the supply valves.
□
Connect the red supply line to the hot water
supply valve.
□
Connect the blue supply line to the cold water
supply valve.
CAUTION: Ensure the supply lines do not kink, twist or
bend into a "V" or "L" shape during installation. Do not use
if there are visible signs of damage.
RED LINE
1
HOT
COLD
A
B
D
5
Please contact 1-855-HD-GLACIER for further assistance.
BLUE LINE
1
2
HOMEDEPOT.COM/GLACIERBAY
Publicidad
