ARDES ARMANI01 Folleto De Instrucciones página 8

When the batteries are flat, they must be replaced with
batteries of the same type:
1 - Use a screwdriver to remove the cover screw (6) and
remove the cover (6).
2 - Remove the batteries.
3 - Insert #3 new LR44 1.5V batteries, observing the polarity
indicated.
4 - Close the cover (6) and fasten the screw.
To remove the batteries, repeat steps 1 and 2.
Motor unit
The motor unit is supplied without batteries.
Ensure that the switch (11) is set to OFF.
1 - Turn the cover (10) counter-clockwise and remove it from
the motor body (13):
2 - Insert #2 x AAA LR03 1.5V batteries, observing the
polarity indicated.
3 - Place the cover (10) on the motor body (13) and secure it
by turning it clockwise:
To remove the batteries, repeat step 1 and remove
the batteries.
OPERATING THE MOTOR UNIT
1 - Select the desired accessory (1-5).
2 - Place the accessory onto the motor body (13) so that it is
firmly secured in place.
3 - Set the switch (11) to ON.
4 - After use, set the switch (11) to OFF to switch off the motor
unit.
OPERATING THE UV LIGHT
To dry the polish:
1 - Turn the base (9) upside down.
2 - Press the button (7) to operate the UV light (8).
3 - Place the nails to be dried beneath the UV light (8).
4 - After use, release the button (7) to switch off the UV light.
Notes:
- Change the position of the nails when drying to dry
them evenly.
- For optimum drying, do not apply a layer of polish
too thickly.
(EN) CLEANING AND MAINTENANCE
This appliance requires no special maintenance; regular
cleaning is all that is required.
Before carrying out any cleaning tasks, ensure that the
appliance is switched off.
Use a soft, damp cloth to clean the base unit.
Use a brush or damp cloth to clean the accessories.
Do not use abrasive substances or chemical solvents.
Attention: keep the appliance dry.
DO NOT SUBMERGE THE APPLIANCE IN WATER.
Problem
(EN) TROUBLESHOOTING
Cause
8 / 28
Solution