PowerA CPAC0235-01 Manual De Usuario página 2

INLINE CONTROL BOX
AC Adapter
Mode Selection
IR REMOTE
Power On
Green
Red
Speed Increase
White
LED Strip
Sensor
Color Selection Power On/Off
Speed Decrease
Mode Selection
RGB LED STRIP SETUP
1. Peel back blue tape adhesive
backing.
2. Press the LED strip firmly against surface when applying to ensure the tape adhesive sets.
NOTE: Any dust or dirt should be wiped clean off desired surface before applying for best hold.
3. Connect the included AC power adapter to the inline control box. The power cable is the single
cable coming out of the side of the control box with the Mode Selection button.
Power Off
4. Connect the 4-pin connector-end of the LED strip to the inline control box. The LED connection
cable is on the same side of the inline control box as the IR sensor cable and the Power button.
Blue
A. NOTE: If the LED lights do not turn on when connected to power, press the Power button on
the inline control box. Also check that the 4-pin connector is correctly oriented with the inline
control box cable end: All 4 pins must line up with the holes in the inline cable end. If the
Cycle Colors
lights do not turn on, unplug the LED strip from the inline cable, flip the light strip connector
end and reconnect to the inline cable.
B.