Beurer BOHL040 Instrucciones Para El Uso página 13

• If you want to use a sunbed within 24 hours of carrying out hair removal, protect your skin by
using suncream.
7. Usage
• Apply the wax in the direction of hair growth, ensuring that the roller rotates and that the device is held at
a 45° angle to prevent wax leaking out.
• Insert the applicator onto the base station between uses to ensure that the wax retains its temperature
and does not leak out.
• The fabric strip must be laid on the skin immediately after the wax is applied. Lay the strip in the direc-
tion of hair growth, covering the entire area, to ensure that the strip sticks to the wax effectively.
• Keep the skin taunt using your free hand and pull away the strip using a firm, backward movement,
against the direction of hair growth and parallel to the surface of the skin.
• Each paper strip can be used several times within each application. The more often the strip is used, the
more firmly it will stick to the hair.
• If the first cartridge has been used up, continue the hair removal process using the replacement cart-
ridge. To do so, remove the cartridge from the chamber with caution, in order to avoid getting burnt, and
insert this into the applicator.
CAUTION
• Only use the warm wax hair remover following the method described in this manual. Only use
beurer wax cartridges.
• Do not treat any sensitive areas such as eyebrows, birthmarks, warts, open wounds, cuts, burns etc.
• This device is not suitable for persons who suffer from diabetes, varicose veins or circulation
problems, or persons who are prone to infections.
• Do not use the wax on irritated skin. Do not apply the wax to areas to which other substances
have already been applied.
• Please do not use any wax on the face area, ear lobes, the inside of the ears, on nipples, or on
irritated, cracked or sunburnt skin.
• If any wax remains on the skin following hair removal, the strip must be reapplied, rubbed down firmly
and pulled off. The remaining wax can also be carefully removed using oil wipes.
• If you want to use the warm wax hair remover again, heat the wax until it is liquid. Hold the applicator
downwards until the remaining wax is hot on the roller. If the wax does not completely liquefy, roll the
wax roller along a fabric strip until the wax roller rotates completely.
• Once you have completed the treatment, place the base device on the base station and leave the wax to
cool. Always position the device upright, to ensure that the wax does not leak out.
8. Cleaning and maintenance
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Do not use the device again until it is completely dry.
• Do not clean the device in the dishwasher.
• Do not use aggressive cleaning agents or hard brushes.
First unplug the device and allow it to cool off. Then you can clean it with a soft, slightly moistened cloth.
Then wipe it dry with a soft, lint-free cloth.
9. Accessories and replacement parts
Accessories and replacement parts are available from the corresponding service address (according to the
service address list). Please state the corresponding order number.
2x wax cartridges + 50 fabric strips
Item number and/or order number
577.01
13