Descargar Imprimir esta página

Costway TQ10072DE Manual De Instrucciones página 7

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 52
Battery Charging
Non-rechargeable batteries are not to be recharged.
Make sure the charger connector is matching with the battery connector.
● Make sure the brand, voltage and frequency of the charger are in
accordance with the wall outlet.
● Batteries are to be inserted with the correct polarity.
● The supply terminals are not to be short circuited.
Battery
charging port
Charge the Battery
The first charge will take about 12 hours.
1. Open the battery charger port (located on the dashboard).
2. Insert the battery charger connector into the charger port.
3. Plug the charger into a standard 120V(240V) wall outlet. Note: The
charger may feel warm during charging.
This is normal and not a cause for concern.
4.After charging is complete(at least 8-10 hours, but not more than twenty
four hours, with the first charge taking about 12 hours)unplug the charger
from the wall outlet and unplug the battery connector from the charger port.
● Plug the battery connector into the charger port.
● Plug the charger into a standard wall outlet.
● Only use the 12 volt charger to charge your 12 volt battery.
Note: if power flow to the wall outlet is controlled by a switch, make sure the
switch is"ON".
12
CAUTION
Charger
● Before first-time use, charge the battery for at least 12 hours.
● Recharge the battery for at least 8-10 hours after each use of your vehicle.
● Do not charge the battery longer than 24 hours.
● Do not charge or store battery upside down. Charging produces explosive
gases. Charge away from flames,sparks and lit cigarettes. Charge in a well
ventilated area.
● Once the battery is charged, disconnect the battery connector from the
charger connector. Unplug the charger from the wall outlet. The battery is
now ready to be installed in your vehicle.
Battery Replacement
1. Remove the screw on the back of the seats and lift the seats out.
2. Disconnect the battery connectors.
3. Remove the four screws on the sides of the battery.
4. Carefully lift the battery out of the battery compartment.
EN
13

Publicidad

loading