Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Fills with the Wrong
Temperature
Water
Cycle Selector
Advances Through Off
• Turn both faucets on fully.
• If equipped with a temperature
selector knob, be sure it is set directly on a
temperature
setting and not between settings.
• Make sure temperature
selection
is correct.
• Make sure hoses are connected
to correct faucets and inlet connections.
Be sure
water supply is regulated
correctly. Flush water line before filling washer.
• Check the water heater. It should be set to deliver a minimum
120° F (49 ° C) hot
water at the tap. Also check water heater capacity and recovery rate.
Disconnect
hoses and clean screens. Hose filter screens may be plugged.
Extra Rinse (select models) is selected.
14
Publicidad
