Descargar Imprimir esta página

BoomToneDJ Maxi Beam 60 Manual Del Usuario página 16

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

DMX connector).
Connect the fixtures one after the other: DMX output to DMX input of the next
fixture. The DMX cable must NEVER be a "Y" cable. The DMX-512 link carries a
high-speed signal. The cables used for this link must be of good quality and in
good condition.
Each fixture must have a specific DMX address to be controlled by the DMX
controller.
Troubleshooting
Here are a few suggestions if you're having problems with your device.
B. The device does not work at all.
3. Check power cord and fuse.
4. Make sure your outlet is properly powered.
B. The device does not respond or does not respond correctly to DMX commands.
5. Check your DMX cables
6. Check your DMX addressing
7. Try another DMX controller
8. Check that your DMX cables do not run close to high-voltage cables, which could
cause interference.
C. Does not react to sound
4) Check the correct mode
5) Check that no DMX cable is connected to DMX IN
6) Tap directly on the microphone to test its responsiveness.
Maintenance
The exterior of the device should be cleaned regularly. Lenses must be cleaned for
optimum brightness. If the device is installed in a dusty or smoky environment, this
regular maintenance is very important. Lenses may also need to be cleaned from the
inside. Unplug before servicing!
16

Publicidad

loading