Publicidad
Idiomas disponibles
Idiomas disponibles
Inspection
Prior to EACH use, inspect SRL for deficiencies,
including,
but
not
limited
to,
corrosion,
deformation, pits, burrs, rough surfaces, sharp
edges, cracking, rust, paint build-up, excessive
heating, alteration, broken stitching, fraying, and
missing or illegible labels. IMMEDIATELY remove
SRL from service if defects or damage are found,
or if exposed to forces of fall arrest.
Take special care to inspect stitching impact
indicator located at webbing loop at top of SRL.
Stitching must be intact and not broken, frayed,
or otherwise compromised. If red tag is visible,
remove from service.
Ensure that applicable work area is free of all
damage, including, but not limited to, debris,
rot, rust, decay, cracking, and hazardous
materials. Ensure that work area will support the
application-specific minimum loads set forth in
this manual. Work area MUST be stable.
At least every 12 months, a Competent Person
(CP) other than the user must inspect SRL.
Inspections MUST be recorded in inspection
log in instruction manual and on equipment
inspection
grid
label.
The
Competent
Person must sign their initials in the box
corresponding to the month and year the
inspection took place.
During inspection, consider all applications and
hazards the SRL has been subjected to.
Product lifetime is indefinite as long as it passes
pre-use and Competent Person inspections.
This inspection log must be specific to one SRL.
Separate inspection logs must be used for each
SRL. All inspection records must be made visible
and available to all users at all times. If equipment
fails inspection it must be discarded immediately.
8
Publicidad
