A-iPower PWF2701SH Manual Del Propietario E Instrucciones página 12

SETUP
ASSEMBLY:
1. Insert the axle through the wheel,
flat washer and frame sleeve in turn,then
insert the pin lock clamp through the
hole on the axle.
See Figure A.
2.
Take out the End Cap in the Frame,attach
the Handle on to the Frame by inserting
the clip. See Figure B.
3. Attach the hose Holder to the Panel.
See Figure C.
Figure A
Figure B
Figure C
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
4. Connect the Pressure Hose to the Pump
hand, DO NOT use any tool to tighten.
See Figure D.
5. Connect the Pressure Hose to the
handle of the Spray Gun and tighten the
See Figure E.
6. Remove the protective cap on the Wand
inlet. Insert the Wand into the Spray Gun
See Figure F
10
Figure D
Figure E
Figure F
Wand
Spray Gun Tip