Publicidad
Idiomas disponibles
Idiomas disponibles
STRUCTURE AND PARTS
1.
Switch (I=750W, II=1500W)
2.
Thermostat
3.
Oscillation Button
4.
Indicator light
5.
Outlet
6.
Base
HOW TO OPERATE
1.
Remove the unit from the box and take off any protective wrapping.
2.
Place the heater on a smooth level surface at least 30cm away from any obstacles.
3.
Plug your fan heater into the power supply. Make sure your power supply corresponds to the
power indicated on the rating label.
4.
Turn the knob to "I" for the warm wind-low power 750W, then turn the knob to "II" for hot
wind-maximum power 1500W.
5.
Turn the thermostat switch clockwise or anti-clockwise to set the desired temperature. The
thermostat switch will keep the room temperature at the required level automatically.
Note: Do not force the knob beyond its normal stop position.
OVERHEATING SAFETY DEVICE
Your heater is fitted with a safety device that switches off the heater in the event of overheating.
If the heater stops working, turn the heater off and inspect the blockage of the inlet or outlet. Wait at
least 5 minutes for the protection system to reset before attempting to restart the heater.
If the safety device still switches the heater off and makes the heater fail to operate, take the heater to
your nearest service center for inspection or repair.
CLEANING YOUR FAN HEATER
1.
Always disconnect the appliance from the main supply before cleaning.
2.
Clean the outside of the heater by wiping with a damp or dry cloth.
3.
Do not use petroleum, or any other detergent or chemical solvent to clean the heater.
Safety precautions:
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
- Designs and specifications are subject to change without notice.
- All logos, brands or brand logos and product names are trademarks or registered trademarks of their
respective holders and are hereby recognised as such.
- This manual was produced with care. However, no rights can be derived. König Electronic can not
accept liability for any errors in this manual or their consequences.
- Keep this manual and packaging for future reference.
To reduce risk of electric shock, this product should ONLY be
opened by an authorised technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
3
3
2
4
5
6
1
Publicidad
