Philips GC9650 Manual Del Usuario página 12

ENGLISH
12
Problem
The ironing board
cover becomes
wet or there are
water droplets on
the garment during
ironing.
Water droplets
come out of the
soleplate.
Steam and/or water
come out from
under the EASY DE-
CALC knob.
Storage
1 Switch off the appliance and unplug it.
2 Remove the water tank and empty it.
3 Put the iron on the iron platform. Push the carry lock to lock the
iron onto the platform.
4 Fold the supply hose and mains cord. Put them in their respective
storage compartments.
5 You can carry the appliance with one hand by the handle of the iron.
Do not carry the appliance by holding the water tank release lever.
Troubleshooting
This chapter summarises the most common problems you could encounter
with the appliance. If you are unable to solve the problem with the
information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Consumer Care Centre in your country.
Possible cause
Steam has condensed on the
ironing board cover after a long
ironing session.
You have an ironing board cover
that is not designed to cope
with the high steam rate of the
appliance.
The steam that was still present
in the hose has cooled down and
condensed into water. This causes
water droplets to come out of
the soleplate.
The EASY DE-CALC knob is not
tightened properly.
The rubber sealing ring of the
EASY DE-CALC knob is worn.
Solution
Replace the ironing board cover if the foam
material has worn out. You can also add an
extra layer of felt material under the ironing
board cover to prevent condensation on
the ironing board. You can buy felt in a fabric
shop.
Put an extra layer of felt material under
the ironing board cover to prevent
condensation on the ironing board. You can
buy felt in a fabric shop.
Steam away from the garment for a few
seconds.
Switch off the appliance and let the
appliance cool down for 2 hours.
Unscrew the EASY DE-CALC knob and
screw it back onto the appliance properly.
Note: Some water may escape when you
remove the knob.
Contact an authorised Philips service centre
for a new EASY DE-CALC knob.