Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT: it is possible to set 12°C simultaneously in each of the zones. However, and for optimal
performance, it is recommended to select two different temperatures of at least 4°C (example: 5°C at the top
and 9°C at the bottom). The maximum temperature difference between the two zones is 10°C. Always set the
coldest zone in the upper compartment and the warmest zone in the lower compartment (example: 5°C at
the top and 15°C at the bottom).
Display brightness
1.
Lightly touch and hold the UP key (key n°2 for AVU31DHD and AVU61DHD) for 5 seconds to enter Settings mode
and then touch the POWER key once.
2.
Use the UP and DOWN keys to select the brightness of the display when the door is close. When the door is open,
the display brightness returns to its normal level.
d0: off
d1: dimmest setting (default)
d2: medium setting
d3: brightest setting
3.
Touch and hold the UP key for 5 seconds to confirm the selection.
Interior lighting brightness
1.
Lightly touch and hold the UP (key n°2 for AVU31DHD and AVU61DHD) key for 5 seconds to enter Settings mode
and then touch the POWER key twice.
2.
Use the UP and DOWN keys to select the brightness of the interior lighting when the door is close. When the door is
open, the interior lighting returns to its normal level
L0: off when the door is close or open
L1: dimmest setting
L2: medium setting
L3: brightest setting (default)
3.
Touch and hold the UP key for 5 seconds to confirm the selection.
Temperature display
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the inner
temperature will not immediately be the temperature setting on the display. Indeed, it is necessary to wait
a few hours for a temperature adjustment of the wine cellar in order to have a homogeneous temperature.
To avoid excessive condensation when the ambient temperature is above 28°C, do not lower the
temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is imperative to wait
5 minutes before turning it on again.
Temperature alarm
Display show at its setting.
Your appliance is equipped with a visual and audible temperature alarm. If the error codes HH and LL
appear on the control panel display, check that you are not in the following situations:
- The appliance door is not closed properly
- The appliance has been switched on within the last 24 hours, or you have added a large
47
Publicidad
