Publicidad
Rear Panel Connectors
Figure 5
#
Item
This is used to connect an external power
1
Power input
adapter to the switch.
Table 5
Top Panel Connectors
1
Figure 6
#
Item
1
Switch ground
This is used to connect the switch to ground.
This is used to connect the switch to external
2
Terminal block
power sources and relays.
Table 6
Hardware Installation
Before You Begin
Observe the following precautions to help prevent
shutdowns, equipment failures, and personal injury:
•
Install the DIS-200G in a cool and dry place. Refer
to the technical specifications in the user manual
for the acceptable operating temperature and
humidity ranges.
•
Leave at least 10 cm of space at the top, rear and
bottom of the switch for ventilation.
•
Visually inspect the power connector and make
sure that it is fully secured to the power cord.
•
Do not stack any devices on top of the switch.
It is also recommended that power and grounding
1
Description
2
Description
requirements are investigated before mounting the
DIS-200G, as access to the switch may be restricted
once it has been installed.
Mounting the Switch on a DIN Rail
Before beginning either mounting or removing the
DIS-200G from a DIN rail, please ensure that the
DIN rail is level and that the DIN rail mounting kit is
installed correctly on the DIS-200G.
Use the following instructions to install the DIS-200G
on a DIN rail:
1. With the back of the DIS-200G facing the DIN
rail, lower the top part of the rail mounting kit
onto the DIN rail.
2. Push the DIS-200G vertically down and rotate the
bottom of the DIS-200G towards the DIN rail, to
attach the switch to the DIN rail.
Use the following instructions to remove the
DIS-200G from a DIN rail:
1. Push the DIS-200G vertically down to create
enough space at the bottom of the rail mounting
kit to remove the DIS-200G from the DIN rail.
2. Rotate the DIS-200G upwards to remove the
bottom of the rail mounting kit from the rail, and
lift the DIS-200G upwards to remove the whole
of the switch from the DIN rail.
Mounting the Switch on a Wall
The DIS-200G can be installed on a solid surface by
using the included wall mounting plates attached
to the back of the switch. It can also be mounted
using the in-built screw hooks on the underneath
of the switch.
Using the Wall Mounting Brackets
Use the following instructions to install the DIS-200G
on a wall:
1. Remove the DIN rail mounting kit from the back
of the DIS-200G (if present).
2. Align the cross-section of the mounting plates
with the openings on the back of the switch and
secure the plates to the switch with the included
screws.
3. Place the switch with the mounting brackets
installed on the location where you want to
mount it, and use the mounting brackets as a
guide to mark where to drill the screw holes.
4. Drill holes on the marks and insert wall anchors
appropriate for the material of the wall.
3
Publicidad
