Thulos TH-CP310 Manual De Instrucciones página 12

Trimming of beard and mustache.
- Turn the cut length selector and set the desired length. (Fig. 4 - Table).
- If this is the first time you use the machine, start using the maximum length to avoid
accidents such as cutting too short hairs.
- Turn on the machine.
- The surface of the comb must be touching the skin (Fig. 5).
- For an effective cut, move the machine towards against hair.
NOTE: Since all hairs do not grow in the same direction, you can cut in different directions,
that is, up, down or diagonally.
- If there are hairs accumulated in the comb, stop the machine and clean it (Fig. 6).
Turn off the machine, remove the comb and remove the accumulated hairs by blowing,
shaking or with the cleaning brush.
Profile and define lines.
- Remove the Comb.
- Without the comb, be careful, the blade cuts off all the hair it touches.
- Profile the neck and face line, touching the edge of the blade with the skin.
Cordless Trimming
5