Publicidad
Idiomas disponibles
Idiomas disponibles
Charging with USB cable
1. Make sure the product is switched off.
2. Connect the adapter cable to the trimmer and the adapter plug it into power.
The charging LED light up red to indicate that the batteries are being charged.
3.
Operating time
When the product is fully charged, it has a cordless operating time of up to 60 minutes.
Using the product
Note: This product is for cordless use.
- Check the product and all accessories before using.
- Do not use the product or any accessory if it is damaged, as this may cause injury.
- Always replace a damaged part with one of the original type.
- This product is for use on facial hair, body parts or scalp hair.
- Use this product for its intended household use as described in this manual.
- For hygienic reasons, the product should only be used by one person.
- Trimming is easier when the skin and hair are dry.
- Be careful when trimming without comb, the product cuts every hair you touch when it is lit.
- Before using the product, always check the blade for damage or wear. If the blade is damaged or
worn, do not use the product, as injury may occur.
Replace a damaged blade before you use the product (see 'Replacement').
- Use the product to trim, edge or shave facial hair (beard, moustache and sideburns).
- Shave for a smooth result, trim to obtain a certain length and edge to create perfect edges and sharp
lines.
- Take your time when you first start to use the product. You have to acquire practice with the product.
SHAVING.
- Turn on the device.
- Make sure that the blade is in full contact with the skin by placing it flat on the skin. (Fig. 2).
- For the best result, move the product against the grain.
- Make long strokes while pressing lightly.
- Shaving a clean beard and face gives the best results.
- Turn off, clean and grease the appliance after each use (in that order).
Note: Make sure you hold the surface of the blade flat against your skin(Fig.3).
Publicidad
