Premier ED-4381 Manual De Instrucciones página 8

REGULATING THE THERMOSTAT
When the room has reached the required temperature turn the right thermostat knob
(where included). In an anti-clockwise direction up to the point where the appliance
switches off and not beyond. The temperature fixed in this way will be automatically
regulated and kept at a constant level by the thermostat.
CLEANING AND MAINTENANCE
Before cleaning always remove the plug from the electrical socket.
Clean the air inlet / outlet grilles frequently.
Never use abrasive powders or solvents.
WARNINGS
- Do not use the haeter in the immediate surroundings of a bath, a shower or a swimming
pools.
- Always use the heater in an upright position.
- Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles
(danger of overheating).
- The heater must be positioned at least 50cm from furniture or other objects.
- When the appliance is used in portable version, do not place it up against walls,
furniture, curtains, etc.
- The appliance must be installed so that the switches and other controls can not be
reached by persons using the bath tub or the shower.
- This appliance comes with a Y-type connection. Replacement of the feed cable must be
entrusted to a technician only, because such work requires special tools.
- The appliance must not be positioned directly underneath a fixed power point.
- Do not use the appliance while it is cooling down, in order to avoid overheating with the
attendant risk of fire.
2
- Do not use the appliance in rooms less than 4m area.
- The heater must not be located immediately below a socket-outlet.
The heater is fitted with a safety device which will switch off the heater in case of
accidental overheating (eg. Obstruction of air intake and outlet grilles, motor turning
slowly or not at all).
To reset, disconnect the plug from the power for a few minutes, remove the cause of
overheating then plug the appliance in again.
VOLTAGE : AC220V/50Hz
POWER : 1800W (MAX)
P-3