Button /
Connector
MODE
Press to enter set up mode stepping through Emissivity set up, Trigger Lock and
SET
Details refer to the below Emissivity, Trigger Lock and Switching ºC/ºF topics.
When the Thermometer enters the setup up mode, press
details refer to the below Emissivity, Trigger Lock and Switching ºC/ºF topics.
After connecting the USB cable, the Thermometer automatically selects USB
USB port
Infrared thermometers measure the surface temperature of an opaque object. The Thermometer's
optics sense infrared energy, which is collected and focused onto a detector. The Thermometer's
electronics then translate the information into a displayed temperature reading which appears on
the display. The laser is used for aiming purposes only.
The Thermometer turns on when you press the trigger.
The Thermometer turns off when no activity is detected for 8 seconds.
To measure temperature, aim the Thermometer at the target, pull and hold the trigger. Release
the trigger to hold a temperature reading.
Be sure to consider distance-to-spot size ratio and filed of view. The laser is used for aiming only.
LOCATING A HOT OR COLD SPOT
To find a hot or cold spot, aim the Thermometer outside the target area. Then, slowly scan across
the area with an up and down motion until you located the hot or cold spot. See Figure 5.
Table 2. Buttons and Connector
Press MODE button to toggle between MAX, MIN, DIF, and AVG options.
Press MODE to turn the Thermometer on again and displays the last
Press
to turn the display backlight on and off.
Press
to turn the laser on and off. After laser is on,
When the Thermometer enters the user setup mode, press
option, details refer to the below Emissivity, Trigger Lock and Switching
power supply and two levels white colour Backlit Display will be on.
HOW THE THERMOMETER WORKS
OPERATING THE THERMOMETER
Description
measurement result.
Switching ºC/ºF set up.
icon will be on and off also.
ºC/ºF topics.
to select an option,
will be shown.
to select an
25