Publicidad
Idiomas disponibles
Idiomas disponibles
6. Before installing reverse (outside)
V-belt, turn belt "inside out". Twist so
wide, flat surface of belt is to inside.
7. Wrap V-belt around reverse idler
pulley and reassemble idler to idler
arm. Tighten securely.
Be sure belt is
between reverse idler pulley and idler
arm pin.
8. Install belt to outside groove of trans-
mission pulley. Be sure belt is inside
all belt guides and rests on outside
groove of engine pulley.
CHECK TINE OPERATION
9. See "TINE OPERATION
CHECK" in
this section of manual.
10. Replace belt guard.
FRONT
VIEW REFERENCE
Reverse Idler Pulley..
Idler Arm Pin
Pulley
FORWARD
MOTION
(INSIDE)
V-BELT
Idler Pulley
Belt Guide
Forward
Idler
_
Pulley
Transmission
Pulley
REVERSE (OUTSIDE) V-BELT
Reverse Idler Pulley
Reverse Idler Arm
Reverse \%
Idler
,2
Pulley_
Idler
/
Arm
Pin_
Engine'!_ \_ "t
Pu,,ey
Belt Guide'<
'
Forward
Idler Pulley
Reverse (OUTSIDE) V-Belt
Forward Motion
(INSIDE) V-Belt/
Bolt
Transmission
Pulley
ENGINE
Maintenance, repair, or replacement
of
the emission control devices and systems,
which are being done at the customers ex-
pense, may be performed by any non-road
engine repair establishment or individual.
Warranty repairs must be performed by an
authorized engine manufacturer's
service
outlet.
TO ADJUST CARBURETOR
The carburetor has been preset at the
factory and adjustment should not be
necessary.
However, engine performance
can be affected by differences in fuel, tem-
perature, altitude or load. If the carburetor
does need adjustment,
contact your near-
est authorized service center/department
IMPORTANT:
Never tamper with the
engine governor, which is factory set
for proper engine speed. Overspeeding
the engine above the factory high speed
setting can be dangerous.
If you think
the engine-governed
high speed needs
adjusting, contact your nearest sears or
other qualified service center which has
the proper equipment and experience to
make any necessary adjustments.
Idler Pulley
15
Publicidad
