cecotec CONGA 5000 MATTRESS LIBERTY Manual De Instrucciones página 45

Once the filter has dried completely, reassemble it.
3.
UV light cleaning Fig 4.
The quartz lamp tube should be cleaned regularly, so as not to affect the effectiveness of
-
UV penetration and the intensity of the exposure.
First, confirm that the device is switched off, then turn it downwards, remove the screws
1.
of the UV light cover with a crosshead screwdriver, open the UV light cover upwards (1)
and then gently clean the lamp tube (2).
Screw the UV light cover back on.
2.
Cleaning the brush Fig. 5
First of all, switch off the power supply, turn the device upside down, loosen the cover
1.
with a crosshead screwdriver.
2. Pull out the gear end of the brush, then remove the roller brush to clean it.
3. Once clean, insert the brush through the end of the gear.
Put it in position, cover the brush cover and tighten the screws.
4.
Clean the dust tank frequently to prevent failure of the appliance.
-
Clean the outside surface with a soft cloth or sponge with mild detergent. Be careful not
-
to get the electrical components of the appliance wet.
Keep the tank and filter dry before reinsertion.
-
Do not place heavy objects on the appliance.
-
5. TROUBLESHOOTING
Problem
The appliance does not
switch on
The device emits an
abnormal sound
Reduced vacuuming capacity The dust tank is full, or the
Possible cause
No battery.
Power button is not turned on.
The dust tank is full, or the air
duct is blocked.
filter is dirty.
Solution
Recharge the battery.
Press the button again.
Remove the dust tank and
clean the obstruction.
Clean the dust in the tank and
filter.
CONGA 5000 MATTRESS LIBERTY
ENGLISH
45