Beurer TB 30 Manual De Instrucciones página 21

Fitting the brush head
Place the brush head
ove until it clicks into place
brush head
ON/OFF/Mode button
6.2 Starting use
1. To switch on the electric toothbrush, briefly press
the ON/OFF/Mode
brush vibrates briefly every 30 seconds to remind
you to clean all 4 jaw quadrants for the same
amount of time
an automatic timer and vibrates three times after
2 minutes. The toothbrush switches off automa-
tically after 6 minutes.
2. Select your desired mode by pressing and hol-
ding the ON/OFF/Mode button
modes are available:
"clean"
"sensitive"
Differentiation of modes based on rotation
speed: Faster rotation if "clean" is selected Slo-
wer rotation if "sensitive" is selected
3. To cancel a session prematurely, briefly press the
ON/OFF/Mode button
4. Clean the device as described in Chapter "Clea-
ning and maintenance".
7. CLEANING AND
MAINTENANCE
Clean the device and the brush head
use.
To do so, proceed as follows:
1. Pull the brush head
2. Clean the brush head
Make sure to clean the inside of the brush head
as well.
3. Clean the device under running water
submerge the device in water. Water might enter
the device and damage it.
4. Regularly clean the base charger
cloth and a mild soap solution. Do not use any
abrasive cleaning products. Keep the base char-
ger
4
adapter away from water
points in the same direction as the
1
We recommend changing the brush
head after 3 months. If the bristles
1
of the brush head are worn or frayed,
they may need to be replaced more
frequently.
For thorough and complete
cleaning
For gentle and gum-friendly
cleaning
and the USB charging cable with mains
onto the device from ab-
1
B
2 .
button. The electric tooth-
2
. The electric toothbrush has
C
.
2
upwards and off.
1
under running water
1
21
. Make sure that the
. The following
2
1
with a damp
4
after each
.
D
1
. Do not
E