Serenco POWERHAND LIGHTING SIN-100.2165 Instrucciones De Uso página 2

UK NL DE FR
Technical Data:
Type LED: SMD
Brightness: 15 ~ 300 Lumen
Battery: 3.7 V 2.0 Ah
IP rating: IP42
IK rating: IK07
Charging time: 4 hours
Run time: 5 hours to 10 hours
Working temperature: -20 ~ 50°C
Product dimensions: 185x145x45 mm
Power connection:
Use the lamp within places prescribed and governed by current regulations on workplaces and electrical systems. Check that the plug
fitted on the cable is suitable for the work environment, if it is not, it must be replaced by a qualified electrician.
Main features:
• SMD LED technology
• SMD LEDs provide 15 ~ 300 Lumen
• Handsfree operating
• Low power consumption, low heat emission
• Battery charge level indicator for easy monitoring
• Lamp use is not affected by cold temperatures
• Cordless design improves safety, convenience and flexibility
• 2 Internally mounted magnets, 2x 22 N
• 3.7 V 2.0 Ah Li-Ion battery provides 5 - 10 hours constant light output
• IP42 rated
• IK07 rated
• CRI 80
• Robust, shock resistant housing
• M8 hole to support with tripod
• Broad 120° light spread
Instructions for use:
• Charge the battery for at least 8 hours before first use
• To charge the lamp, connect the cable via the USB-C to the lamp directly. Then connect the USB plug to either the 100 ~ 240 V adapter (optional) or
any other USB power source available
• The charge level indicator displays 1 green LED to indicate when charging is complete
• The charge level indicator will show 1 flashing LED when charging is required, please re-charge in good time
• The work lamp is controlled by 2 buttons. The push button controls the light by an on/off selection. When the light is lit, press and hold the ON /
OFF button to adjust the light intensity between 15 and 150 lumens, (dimmer function)
• Memory function: the lamp will turn on in the last used position
• Do not leave the battery in a fully discharged condition. Recharge the lamp at least once every 30 days. Always fully charge the battery to extend
the battery lifetime. Always use the original charger
Accessories and spare parts:
USB-C cable
100 ~ 240 V charger optional (SIN-100.1001A)
Use only accessories and spare parts approved by the manufacturer.
Caution:
• Avoid looking directly into the beam
• Do not use the lamp near open flames
• Switch off the lamp when not in use
• Only use this lamp for the purpose it is designed to, all modifications are strictly prohibited
• Should any cable be damaged, it must be immediately replaced with one of the same type
• When plugging the charger into a suitable mains supply, always check that the device is in good condition, and does not appear damaged as this
may impair safety
Warranty/Service:
• 12 months from the date of the purchase – Proof of purchase is required to make any warranty claim
• The warranty does not apply in case of damage to the device due to negligent / improper use or accidental damage
2
ES
Lumen Laser class I
Protection class III
EAN: 8717775514701
Colour temperature: 6500 K
Weight: 230 g
Technical data optional charger (SIN-100.1001A):
Voltage: AC 100 V ~ 240 V
Frequency: 50/60 Hz
Charger output voltage: 5 V 1 A
Flexible
M8 hole to support
with tripod
2x 22 N
ON/OFF/DIMMER