Beurer TB 50 Manual De Instrucciones página 22

6.2 Starting use
1. To switch on the electric toothbrush, briefly press
the ON/OFF/Mode
brush vibrates briefly every 30 seconds to remind
you to clean all 4 jaw quadrants for the same
amount of time
an automatic timer and vibrates three times after
2 minutes. The toothbrush switches off automat-
ically after 6 minutes.
2. Select your desired mode by pressing and hold-
ing the ON/OFF/Mode button
selected mode will light up in the mode indicator
3 . The following modes are available:
"clean"
"sensitive" For gentle and gum-friendly
"white"
3. To cancel a session prematurely, briefly press the
ON/OFF/Mode button
4. Clean the device as described in Chapter "Clean-
ing and maintenance".
7. CLEANING AND
MAINTENANCE
Clean the device and the brush head
use.
To do so, proceed as follows:
1. Pull the brush head
2. Clean the brush head
. Make sure to clean the inside of the brush
E
head
3. Clean the device under running water
submerge the device in water. Water might enter
the device and damage it.
4. Regularly clean the base charger
cloth and a mild soap solution. Do not use any
abrasive cleaning products. Keep the base
We recommend changing the brush
head after 3 months. If the bristles
1
of the brush head are worn or frayed,
they may need to be replaced more
frequently.
The electric toothbrush has a pres-
sure sensor. As soon as you press
the brush head
your teeth or gums during use, the
light ring
Figure
For thorough and complete
cleaning
cleaning
Cleaning for natural teeth
whitening
as well.
1
2 button. The electric tooth-
C . The electric toothbrush has
will illuminate red (see
4
D ).
.
2
1 upwards and off.
1 under running water
22
1 too firmly onto
2 . The currently
1
with a damp
5
after each
. Do not
F