Operation - EASYHOME MA 501-I Manual Del Usuario

Strip Cut Paper Shredder
1. Take the paper shredder out of the packaging.
2. Check whether the paper shredder or the individual parts exhibit damage. If
this is the case, do not use the paper shredder. Contact the manufacturer at the
service address specified on the warranty card.
3. Check to make sure that the delivery is complete (see fig. A).

Operation

NOTICE!
Risk of damage!
Incorrect handling with the top document shredder can lead
to damage to the motor or to the inner rollers.
− Avoid overloading the motor by not putting more than 6
sheets of paper (80 g/m
− Do not shred formats larger than A4 or continuous paper.
− Unplug the device if the motor cuts out because of over-
loading. Ensure that the slide switch is at OFF. Leave the
motor to cool for about 30 minutes to room temperature,
before you plug the shredder back in. You can then continue
with operations.
− Remove paper clips, staples and similar fixings before you
start shredding.
Short-term operation:
• The shredder is suitable only for short-term operation and
• The shredder motor switches off automatically if it overheats.
Ideally, use a round wastebasket with a diameter of between 27.5 cm and 37.5 cm.
1. If necessary, pull off the mounting rail
waste bin.
2
not for continuous use. After continuous operation of a maximum
of 1 minute, let the shredder rest for 30 minutes, to prevent
overheating of the device.
) into the slot at the same time.
and place the shredder on the
4
Operation
13