Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT
SAFETY INSTUCTIONS
INSTALLER:
IM PC RTANT:
Im portant safety
instruction
Equipment
and usage safety
requirements
READ AND SAVE THESE INSTRUCTIONS
LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE AFTER INSTALLATION IS
COMPLETE.
SAVE FOR THE LOCAL INSPECTOR'S USE.
A WARNING: Improper installation, adjustment, alteration, service or maintenance
can cause injury or property damage. Refer to this manual. For assistance or
additional information consult a qualified installer, service agency, or manufacturer.
Have the installer show you the location of the circuit breaker or fuse. Mark it for
easy reference.
Be sure your appliance is properly installed and grounded by a qualified technician.
Never modify or alter the construction of the appliance. For example, do not remove
leveling legs, panels, wire covers or anti-tip brackets/screws.
Remove all tape and packaging before using the appliance. Destroy the packaging
after unpacking the appliance. Never allow children to play with packaging material.
Before you plug in an electrical cord, be sure all controls are in the OFF position.
To eliminate the risk of burns or fire by reaching over heated surface units, cabinet
storage space located above the surface units should be avoided. If cabinet storage
is to be provided, the risk can be reduced by installing a range hood that projects
horizontally a minimum of 5 inches (12.7 cm) beyond the bottom of the cabinet.
This appliance has been tested in accordance with ANSI/UL 858 Standard for
Safety for Household Electric Ranges and CAN/CSA-22.2
No.61 National Standard
of Canada for Household Cooking Ranges. It is the responsibility of the owner and
installer to determine if additional requirements and standards apply in specific
installations.
Before you begin
Tools and parts needed
Note:
Parts included
1.
Philips head screwdriver
2.
Pencil
3.
Drill with 1/4 " bit
4.
Jigsaw
5.
Tape measure
Additional materials may be necessary for installation in solid surface countertops.
Contact the countertop manufactor.
1.
Hold down brackets
2.
Clamping screws (4)
3.
Sheet metal screws (4)
3
Publicidad
