Publicidad
Idiomas disponibles
Idiomas disponibles
Simple Repair Methods
Problem
Not enough heat or Too heat
No steam or Leakage
No burst of steam or no
vertical steam
Leaking water from Soleplate
Little Steam
No Spraying
TECHNICAL SPECIFICATION
Voltage: AC 220V - 240V~
Frequency: 50Hz-60Hz
Power: 3100W
Correct Disposal of this product:
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return your used device, please use the return and collection
systems or contact the retailer where the product was purchased, they can take this product for environmental safe
recycling
Possible Reasons
Rotate thermostat dial improperly or
unplugging
The thermostat dial has been set to MIN
The (vertical) burst of steam function has
been used too often within a very short
period. The iron is not hot enough
Set the thermostat dial out of steam range.
The heat is still not enough.
The water is over than max position
Check if the steam selector is in proper
location.
Steam hole is blocked.
Too little water in the water tank
No enough pressure or air inside
Measurement
Correct Thermostat dial in position and
check if the iron is plugged.
Set the thermostat dial to the required
positioin.
Continue ironing in horizontal position and
wait a while before using the (vertical) burst
of steam function again
Set the thermostat dial as per steam range.
Open steam button only after the indicator
light goes off.
Pour out the remaining water
Set the steam selector to the proper
location.
Clean hole with distilled water.
Fill water into the box
Press the spray nozzle by hand, and push
the spray button several times continuously.
5
Publicidad
