Uline HOOVER H-3482 Manual Del Usuario página 2

This appliance must
be grounded. If it
should malfunction
or break down,
grounding provides
a path of least
resistance for
electric current to
reduce risk of
electric shock.
The appliance is equipped with a cord having an
equipment-grounding conductor and grounding plug.
The plug must be inserted into an appropriate outlet
that is properly installed and grounded in accordance
with all local codes and ordinances.
CARTON CONTENTS
Unpack cleaner from the carton and identify the parts
shown. Remove and dispose of the packaging.
B
A
ATTACH UPPER HANDLE
1. Remove clean solution tank
(upper tank). (See Figure 1)
2. With cord hook to back of cleaner,
push upper handle down onto
lower handle. (See Figure 2)
3. Push bolts into holes on front of
handle. If bolts will not go through
hole easily, handle is not pushed
completely down. (See Figure 3)
4. Place nuts in recessed areas on
back of handle. Hold each nut in
place while tightening each bolt
securely with a Phillips screwdriver.
PAGE 2 OF 24
SAFETY CONTINUED
GROUNDED
OUTLET
GROUNDING PIN
GROUNDED OUTLET BOX
A. Spotter/carpet
cleaner
B. Upper handle
D
C
C. Bolts (2)
D. Nuts (3 - one
extra included)
E
E. Carpet/
Upholstery
Detergent
Figure 2
WARNING! Improper connection of the
equipment-grounding conductor can result
in a risk of electric shock. Check with a
qualified electrician or service person if
you are in doubt as to whether the outlet is
properly grounded. Do not modify the plug
provided with the appliance. If it will not fit
the outlet, have a proper outlet installed by
a qualified electrician. This appliance is for
use in a nominal 120 volt circuit and has a
grounding attachment plug that looks like the
plug illustrated in the sketch above. Make sure
that the appliance is connected to an outlet
having the same configuration as the plug. No
adapter should be used with this appliance.
ASSEMblY
Only two nuts are needed on
this model. The extra nut is not
required but has been provided
for your convenience.
(See Figure 4)
5. When handle sections are
completely together, squeeze
trigger (A) on upper handle to
snap trigger
rod in place.
(See Figure 5)
6. Replace clean
solution tank
(upper tank)
by positioning
bottom first.
Figure 1
Press on tank
handle to snap top of tank into place.
(See Figure 6)
7. Press cord into cord clip on back of handle.
Pull cord tight. (See Figure 7)
Figure 5
Figure 4
Figure 6
A
Figure 3
Figure 7
1114 IH-3482