Monacor International JTS IN-264TH/2 Manual De Instrucciones página 11

5.1.5 Identification number
To enable the REMOSET transmission between
the transmitter and the receiver unit, match their
identification numbers.
1) Keep the button SET (4) pressed until the dis-
play briefly shows
ting mode (group indication starts flashing).
2) Press the button SET repeatedly until the dis-
play shows and the current identification
number ( ... or
3) In the setting range
the button (3) to search in descending order
or press the button
order. Use the corresponding arrow button to
set the transmitter to the identification number
of the receiver unit (the transmitter will only
respond to the REMOSET signal of this receiver
unit) or select
to the REMOSET signal of any receiver unit).
4) Press the button SET to confirm. The display
briefly shows
normal mode.
5.1.6 Lock function
When the lock function has been activated, you will
no longer be able to switch off the unit or to mute
the microphone. From the setting modes, you will
only be able to activate the mode for the lock func-
tion in order to deactivate the lock. When you press
a button, the display will show
Activating the lock
1) Keep the button SET (4) pressed until the dis-
play briefly shows
ting mode (group indication starts flashing).
2) Press the button SET repeatedly until the dis-
play shows
3) To activate the lock, press the button
display shows
4) Press the button SET to confirm. The display
briefly shows
normal mode.
Deactivating the lock
1) Keep the button SET (4) pressed until
flashing in the indication
2) To deactivate the lock, press the button
The display shows
3) Press the button SET to confirm. The display
briefly shows
normal mode.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
and then the group set-
).
, ...
(5) to search in ascending
(the transmitter will respond
. The unit will return to the
(lock on).
and then the group set-
(lock off).
(5). The
.
. The unit will return to the
.
.
. The unit will return to the
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
6 Specifications
Carrier frequency range: . . 740 – 776 MHz
Frequency stability: . . . . . . ±0.005 %
Transmission power: . . . . . switchable
Audio frequency range: . . . 50 – 16 000 Hz
Microphone cartridge: . . . . dynamic / cardioid
Ambient temperature: . . . . 0 – 40 °C
, press
Power supply: . . . . . . . . . . 2 × 1.5 V battery of
Operating time: . . . . . . . . . > 25 h (for alkaline
Dimensions: . . . . . . . . . . . ∅ 50 mm × 250 mm
Weight: . . . . . . . . . . . . . . . 350 g (w/o batteries)
Subject to technical modification.
starts
(3).
table on page 20
10 mW/ 50 mW
size AA (not supplied)
batteries 3400 mAh)
11