Publicidad
Idiomas disponibles
Idiomas disponibles
Setting the biscuit groove size
(see fig . C)
The appliance can cut biscuit grooves in six sizes .
To do this, use the depth adjustment i .
Setting
Biscuit type Cutting depth
0
No . 0
10
No . 10
20
No . 20
S
Simplex
D
Duplex
Max .
‒
♦
Turn the depth adjustment i until the desired
biscuit groove size is set on the ▼ marking on
the upper side .
Setting the biscuit groove depth
(see fig . C)
You can adjust the depth of the biscuit groove if the
depth of the biscuit groove does not correspond
with the size of the biscuit you are using .
♦
Turn the depth adjustment screw u with a
Phillips screwdriver (not supplied):
clockwise: reduce cutting depth
anticlockwise: increase
♦
Carry out a test on some scrap material to
check that the setting is correct .
Angle setting (see fig . E)
The angle stop 4 is adjustable to cut slots with
different angles .
♦
Loosen the angle stop screw d by turning it
anticlockwise .
♦
Set the desired angle using the angle scale g
and the ▼ marking above it .
♦
Re-tighten the angle stop screw d by turning it
clockwise .
■
8
│
GB │ IE
approx . 8 mm
approx . 10 mm
approx . 12 .3 mm
approx . 13 mm
approx . 14 .7 mm
approx . 20 mm
Height stop
The height stop a is fitted in front of the angle
stop 4 . The height stop can be adjusted to match
the thickness of the workpiece .
Fit the height stop (see fig. D)
♦
Undo the height stop lock s .
♦
Align the lower part of the height stop a with
the upper side of the angle stop 4 . Press the
height stop a downwards . The gear wheel on
the back of the height adjustment knob p must
engage in the grooves of the angle stop 4 .
♦
Turn the height adjustment knob p in both
directions to test whether the height stop a
can move in both directions .
CAUTION!
►
If you use the angle stop 4 and the height
stop a at the same time, make sure that the
saw disc j does not come into contact with
the height stop a!
Adjusting the height stop
♦
Undo the height stop lock s . Turn the height
adjustment knob p until you reach the desired
setting .
♦
The values in the scale windows o serve as
reference value . The set height is shown by the
► marking .
♦
After you have set the height, retighten the
height stop lock s .
Removing the height stop
♦
Undo the height stop lock s .
♦
Turn the height adjustment knob p clockwise
until you reach the highest setting and you can
remove the height stop a .
PFDFA 20-Li A1
Publicidad
