Metabo HPT NT 1850DG Manual página 20

English
WARNING
● Keep your finger off the trigger except during
nailing operation, because serious injury could
result if the push lever accidentally contacts you
or others in work area.
● Keep hands and body away from the discharge
area. This metabo HPT nailer may bounce from
the recoil of driving a nail and unwanted
subsequent nail may be driven, possibly causing
injury.
NOTE
○ If all warnings and instructions are followed, safe
operation is possible with system: SINGLE
SEQUENTIAL ACTUATION MECHANISM.
○ Always handle nails and package carefully. If nails are
dropped, collating bond may be broken, which will
cause mis-feeding and jamming.
○ After nailing:
1. remove battery from the Nailer;
2. remove all nails from the Nailer;
ADJUSTING THE NAILING DEPTH
To assure that each nail penetrates to the same depth, be
sure that the Nailer is always held firmly against the
workpiece.
If nails are driven too deep or shallow into the workpiece,
adjust the nailing in the following order.
(1) Remove the battery from the Nailer.
(2) If nails are driven too deep, turn the adjuster to the
shallow side.
Adjustments are in quarter-turn increments.
If nails are driven too shallow, turn the adjuster to the
deep side.
20
Battery
(2)
Too Deep
(2)
Too Shallow
(3) Stop turning the adjuster when a suitable position is
reached for a nailing test.
(4) Connect the battery to the Nailer.
ALWAYS WEAR SAFETY GLASSES.
Perform a nailing test.
(5) Remove the battery from the Nailer.
(6) Choose a suitable position for adjuster.
USING THE HOOK
WARNING
When using the hook, remove the battery. Pay
sufficient attention so that the main equipment
does not fall.
If the tool falls, there is a risk of accident.
Hook can be installed on the left or right side.
1. Removing the hook.
Remove the screws fixing the hook with Phillips screw
driver.
Turn Adjuster
Flush
Turn Adjuster
Flush
Groove
Hook
Screw