Publicidad
Idiomas disponibles
Idiomas disponibles
CYLINDER
I.
Remove
spark plug.
2.
Pour one ounce (29 ml) of oil through
spark plug hole into cylinder.
3.
Pull starter handle slowly a few times
to distribute oil.
4.
Replace
with new spark plug.
OTHER
• Do not store gasoline from one season
to another.
• Replace your gasoline can if your can
starts to rust. Rust and/or dirt in your
gasoline will cause problems.
• If possible, store your unit indoors and
cover it to protect it from dust and dirt.
• Cover your unit with a suitable protec-
tive cover that does not retain moisture.
Do not use plastic. Plastic cannot
breathe, which allows condensation
to
form and will cause your unit to rust.
IMPORTANT:
Never cover mower while
engine and exhaust areas are still warm.
A CAUTION:
Never store the lawn mower
with gasoline in the tank inside a building
where fumes may reach an open flame or
spark, Allow the engine to cool before
storing in any enclosure.
TROUBLESHOOTING
- See appropriate section in manual unless directed
to a Sears
Service
Center.
PROBLEM
CAUSE
Does not start
I,
Dirty air filter.
2.
Out of fuel.
3.
Stale fuel.
4. Water in fuel.
5. Spark plug wire is
disconnected.
6.
Bed spark plug.
7.
Loose blade or broken
blade adapter.
8.
Control bar in released
position.
9.
Control bar defective.
10. Fuel valve lever (if
equipped)
is in the
OFF position.
Loss of power
1. Rear of lawn mower
housing or cutting blade
dragging in heavy grass.
2. Cutting too much grass.
3. Dirty air filter.
4. Buildup
of grass,
leaves,
and trash under mower.
5. Too much oil in engine.
6. Walking
speed too fast.
.
CORRECTION
1, Clean/replace
air filter.
2.
Fill fuel tank.
3.
Drain tank end refill with
fresh, clean fuel.
Drain fuel tank and
carburetor and refill tank
with fresh gasoline.
5.
Connect wire to plug.
6.
Replace
spark plug.
7. Tighten blade bolt or
replace blade adapter.
8.
Depress control bar to
handle.
9.
Replace
control bar.
10 .Turn fuel valve lever to the
ON position.
1. Set to "Higher Cut"
position.
2. Set to "Higher
Cut"
position.
3. Clean/replace
air filter.
4. Clean underside of mower
housing.
5. Check oil level.
6. Cut at slower walking
speed.
17
Publicidad
