Publicidad
Idiomas disponibles
Idiomas disponibles
-
This fan can be installed on a normal or vaulted ceiling with a downrod. The
hanging length can be extended by using a longer downrod.
Assembling the fan based on ceiling type (Fig. 3):
1.
Normal ceilings
2.
Sloped ceilings (might require a longer downrod, not included)
3.
Wooden ceiling. Fig. 4
4.
Concrete ceiling. Fig. 5
To assemble the ceiling fan, follow the steps below (Fig. 3-9):
1.
Remove the lower and upper pins from the downrod and release the hanging
ball at the top of the rod.
2.
Pass the wiring from the main body through the downrod.
3.
Attach the downrod to the main body by inserting the pin through the downrod
and the main-body attachment. Tighten the screws provided on the main-body
attachment to properly secure the downrod.
4.
Remove the 4 screws that fix the upper canopy and the installation bracket.
Insert the upper canopy through the downrod.
5.
Insert the pin through the pin holes located on the upper end of the downrod.
Once inserted, slide the hanging ball upward to the upper end of the downrod
and fix it with one of the screws provided.
6.
Make sure the pin fits in the slots located inside the hanging ball before screwing
it.
7.
Mark the centre of the installation bracket and use both self-tapping screws
provided with their corresponding washers and pressure washers to fix the
installation bracket to a wooden ceiling.
Warning
Self-tapping screws are only suitable for wooden ceilings. In case of installing the
ceiling fan to concrete ceilings or joists, use a drill for making the holes and plugs or
expansion screws (not included).
8.
Remove the screws located on the lower part of the motor through the lamp
support.
9.
Screw the blades to the blade brackets using the bolts, washers, and nuts
provided, then screw the blade-bracket assembly to the main body.
10. Once the installation bracket is screwed, connect the wiring. First connect the
quick-connect cable to the terminal block on the installation bracket. Follow the
colour code. From the opposite end of the terminal block, connect the wiring
from the installation of your home.
11.
Lift the fan previously mounted to the installation bracket and insert the hanging
ball through the installation-bracket hole.
12.
Connect the cables that come out from the downrod to those from the
ENGLISH
EVVO V517 WOOD/ DARK WOOD
45
Publicidad
