Saivod TEIDE 450 T Instrucciones Para El Empleo página 77

MAIN MACHINE FUNCTIONS
A
DESCRIPTION OF FUNCTIONS
M ON/OFF KNOB OR BUTTON
OFF To start the machine, pull programmer knob or if the machine has push-button,
ON
press the start push-button .
The indicator light will be illuminated.
M NO-DRAIN BUTTON:
0
When this button is pushed, the washing machine will stop automatically at the end
1
of the last rinse cycle and before draining the water. In this case, the washing is
held in the water-filled drum to prevent creasing. This function only works for the
delicate wash cycle.
M NO-SPIN BUTTON:
0
Pushing this button the washing machine carries out a normal wash cycle but does
1
not spin.
M HALF-LOAD BUTTON:
0 Pressing this button reduces the quantity of water used during the wash, thus saving
1/2
1
both water and energy.
Use this function when the quantity of items to wash is equal to half the maximum
recommended load (see table "Maximum recommended loads")
M EXTRA RINSE BUTTON:
The washing machine has been designed to reduce water consumption to a minimum.
0
1
Three rinse cycles are normally sufficient. For very soft water zones or for those
who are allergic to detergent residues, press this button and the machine will carry
out an extra rinse.
M COLD WASH:
Depress button marked to give wash programme whithaut any heathing .
0
1
M
TEMPERATURE LIMIT BUTTON:
Pushing this button will limit the temperature to 60° when the temperature dial is
0
1
set at a higher temperature.
M
TEMPERATURE CONTROL(according to the model)
Rotate this knob to set the required temperature.
In order to select the correct wash temperature, refer to the "Programme Table".
Important: programme changes or the selection of the above functions must always be
carried out with the appliance switched off.
VELETA 450- TEIDE 450T
B
A
T **
P
S
B
S
T
P
(Available according to the model)
SM1110
Table of programmes
Buttons
Machine "on" indicator light
Thermostat dial **
accirding to the model
Programmer dial
GB