Publicidad
Idiomas disponibles
Idiomas disponibles
Use rigid or flexible connection pipes
which comply with applicable regula-
tions.
If compression fittings are used, tighten
firmly using two spanners (fig. 8.3).
In particular, make sure that:
– the flexible hose does not come into
contact with any parts of the cooker
with surface temperatures in excess of
70˚K;
– the flexible hose does not exceed 75
cm in length and does not come into
contact with sharp edges or corners;
– the hose is not under tension or twist-
ed and is not kinked or too tightly
bent;
– the connection with rigid metal pipes
should not cause stresses to the gas
ramp.
– we advise replacing the gasket on the
slightest sign of deformation or imper-
fection.
– the hose can easily be inspected
along its entire length to check its con-
dition; hoses should replaced after a
maximum of three years.
– the cylinder cock or the supply cock
immediately ahead of the appliance is
closed whenever the cooker is not in
use.
The fitting (fig. 8.2a - 8.2b) is made up
of:
A - Gas train terminal fitting (rh or lh)
B - Gasket
C - Conical connector - for Holland
D - Hose connector for G 30/G31- for
Spain
A
B
C
Fig. 8.2a
A
B
D
Fig. 8.2b
NL
ES
141
Publicidad
