BaBylissPro 4rtists FXFS2E Manual Del Usuario página 8

ENGLISH
Please carefully read the
safety instructions before
using the appliance.
Adaptor
Vibrations
LpA (dB(A))
CORD/CORDLESS METAL
DOUBLE FOIL SHAVER
FXFS2E - FXFS2GE - FXFS2GSE -
FXFS2IE
OPERATING INSTRUCTIONS
1. Before using the shaver for the
rst time, charge continuously
for 3 hours. Maximum battery
capacity will only be reached
after 3 charging and discharging
cycles.
2. Make sure the switch on the
shaver is in the OFF (O) position.
Connect the charging jack into
the receptacle on the bottom of
the shaver. Plug the adapter into
any electrical outlet (at the vol-
tage listed on the label a xed
to the adaptor). The charging
indicator will light up to indicate
that the charging has begun.
Charging is complete after 3
hours.
3. The adapter may become warm
while charging. This is normal.
4. Preserving the batteries: In
order to maintain the optimum
CA78M
< 2,5 m/s²
< 70
capacity of the rechargeable
batteries, the shaver should be
recharged for 3 hours approxi-
mately every 6 months.
5. Make sure the switch is in the
OFF (O) position when the sha-
ver is not operating.
WARNING: Changes or modi -
cations to this unit not expressly
approved by the party responsible
for compliance could void the
user's authority to operate the
equipment. This device complies
with Part 15 of the FCC Rules.
Operation is subject to the fol-
lowing two conditions: (1) This
device may not cause harmful in-
terference, and (2) this device must
accept any interference received,
including interference that may
cause undesired operation.
NOTE: This equipment has been
tested and found to comply with
the limits for a Class B digital de-
vice, pursuant to Part 15 of the FCC
Rules. These limits are designed
to provide reasonable protection
against harmful interference in a
residential installation. This equip-
ment generates, uses and can
radiate radio frequency energy
and, if not installed and used in
accordance with the instructions,
may cause harmful interference to
radio communications.
However, there is no guarantee
that interference will not occur in a
particular installation. If this equip-
ment does cause harmful interfe-
8