Irradio STV-IR-2242-FIX Manual Del Usuario página 6

wall
TV
(figure 5)
carrier arms
Carrier arms
TV
wall
main plate
(Figure 8)
(figure 8)
Removing the TV from the wall mount
To remove your TV from the wall plate assembly, disconnect all cables and then reserve the proce-
dures.
Care and maintenance
As a good practice of care and maintenance, carry out periodic checks on the tightening of the an-
chors and check the integrity of the product.
(figure 3)
(figure 6)
Wall
Main Plate
(figure 9)
Fix the main plate and the
screws so that the holes coinside
with the plastic dowels (figure 3).
Insert the triphone screws into
(figure 4)
the holes and fix them with a
screwdriver (figure 4).
Adjust the carrier arms
and the screws to the match
the holes on the back of TV
(Figure 5) and fix the screws
with the screwdriver (Figure 6).
Slightly fix the screws in Figure
7 at the appropriate angle
(Do not adjust the tilt with these
parts)
(figure 7)
Place the carrier arms on the main plate
(Figure 8) and adjust the tilt of your TV by
tightening/loosening the screw in Figure 9.
ATTENTION!
Screwdriver and drill
aren't included.
The product is automa-
tically locked, the carrier
arm cannot move when
it comes to the end.