Mark 720-0778A Manual De Instrucciones página 14

Step 3: Side Burner Valve Assembly
3a). Loosen the "C" bracket on the burner tube
located on the underside of the side shelf bowl by
removing the screw holding it in place. Turn the
"C" bracket so the opening of the side burner tube
is exposed.
3b). Remove the 2 screws that are pre-attached to
the valve. Then place the bezel on the side burner
control panel, from underneath, insert the side
burner valve into the side burner control panel and
bezel. Then align the valve through the side burner
panel opening, making sure the orifice end is
aligned in the burner opening. See Fig. 9
3c). From the front of the side burner control panel,
put the two valve screws through the knob bezel
holes, control panel and secure to valve. See Fig.
9
3d). Return to the underside of the side burner and
turn the "C" bracket to close the gap in the front
opening of the side burner tube. Tighten screw to
secure. See Fig. 10
Step 4: Connecting Ignition Wires
Insert the side burner ignition wire to the ignite
module located on the right side panel inside the
cart. See Fig. 11
Assembly Instruction
Fig.9
Holes
Fig.10
Fig.11
14
continued