LG CRD-8360B Manual De Usuario página 5

DIGITAL
AUDIO
BACK VIEW
1 Digital Audio Output Connector
This is a digital audio output connector or Video CD output connector.
You can connect this to the digital audio system or Video CD Board.
2 Analog Audio Output Connector
The Audio Output Connector connects to a sound card.
The supplied audio cable is a SoundBlaster
sound card, you will need to contact the sound card manufacturer to obtain the
proper cable for that card.
3 Master / Slave / CSEL Jumper
These three jumpers are used to set the CD-ROM Drive to either a Master,
Slave, or CSEL drive.
Refer to section HARDWARE INSTALLATION.
4 Interface Connector
This 40-pin connector is used to transfer and control signals between the
CD-ROM Drive and your PC.
Connect the 40-pin IDE cable in your PC to this connector.
5 Power-in Connector
Attach a power cable from the computer to this connector.
ANALOG
AUDIO
D G R G L C S M
S L A
1 2 3
Figure 2. Back View
INTERFACE
39
40
4
® type cable. If you have a different
E-5
POWER
+5 +12
GND
1
2
5