Publicidad
Idiomas disponibles
Idiomas disponibles
11. OPERATING INSTRUCTIONS
IMPORTANT: Do not start the vehicle with
the charger connected to the AC outlet,
or it may damage the charger and your
vehicle.
NOTE: This charger is equipped with an
auto-start feature. Current is supplied
to the battery clamps before a battery is
connected, and the clamps may spark if
touched together.
CHARGING A BATTERY
IN THE VEHICLE
1. Turn off all the vehicle's accessories.
2. Keep the hood open.
3. Clean the battery terminals.
4. Place the charger on a dry, non-
flammable surface, or use the
convenient hook attachment to hang
the unit safely outside the work area.
5. Lay the AC/DC cables away from any
fan blades, belts, pulleys and other
moving parts.
6. Connect the battery, following the
precautions listed in sections 6 and 7.
7. Connect the charger to a live
grounded 120V AC outlet.
8. The green
9. When charging is complete,
disconnect the charger from the AC
power, remove the clamp from the
vehicle's chassis, and then remove
the clamp from the battery terminal.
CHARGING A BATTERY
OUTSIDE OF THE VEHICLE
1. Place battery in a well-ventilated area.
2. Clean the battery terminals.
3. Connect the battery, following the
precautions listed in sections 6 and 7.
4. Connect the charger to a live
grounded 120V AC outlet.
5. The green
6. When charging is complete,
disconnect the charger from the AC
power, disconnect the negative clamp,
and finally the positive clamp.
7. A marine (boat) battery must be
removed and charged on shore.
USING THE QUICK-CONNECT
CABLE CONNECTORS
Connect either of the two (2) output cable
leads to the charger. Make sure to place
the charger on a dry, non-flammable
surface.
Power LED will light.
Power LED will light.
WARNING: Never connect the clamp and
ring terminal connectors together for use
in other applications, such as external
battery or other power source charging,
or to extend the output cable length,
as reverse polarity and/or overcharge
conditions will occur.
BATTERY CLAMP QUICK-CONNECT
1. Connect the end of the charger output
cable to the end of the battery cable
quick-connect and clamps.
2. Follow the steps in sections 6 and 7,
to connect the output clamps to the
battery.
3. Connect the charger to a live 120V AC
outlet.
RING TERMINAL QUICK-CONNECT
1. To permanently attach to a battery,
loosen and remove each nut from the
bolt at the battery terminal.
2. Connect the red POSITIVE connector
ring to the POSITIVE battery terminal.
3. Connect the black NEGATIVE
connector ring to the NEGATIVE
battery terminal.
4. Replace and tighten the nuts to secure.
5. Connect the cable to the end of the
charger output cord. Take care to keep
the wires and plug away from metal
and moving parts.
6. Connect the charger to a live
grounded 120V AC outlet.
BATTERY CHARGING TIMES
APPLICATION
POWERSPORTS
AUTOMOTIVE
MARINE
Times are based on a 50% discharged
battery and may change, depending on age
and condition of battery.
AUTOMATIC CHARGING MODE
When an automatic charge is performed,
the charger switches to the maintain
mode automatically after the battery is
charged.
• 8 •
BATTERY
CHARGING TIME (Hours)
SIZE
2A
6A
8A
6Ah
6
2
1.75
32Ah
15
5
4.5
300 CCA
12
4
3.5
1000 CCA
30
10
8.5
50Ah
15
5
4.25
105Ah
33
11
9.5
10A
1.5
4
3
7
3.5
8
Publicidad
