Descargar Imprimir esta página

IKRA ILWH 3000 Instrucciones De Manejo página 17

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 30
MAINS CONNECTION
DANGER
Appliances used at many different locations including
wet room and open air must be connected via a residual
current device (FI, RCD, PRCD) of 30mA or less.
Before use check machine, cable, and plug for any dama-
ges or material fatigue. Repairs should only be carried out
by authorised Service Agents.
Insert the plug of the electrical cable in a socket of suitable
shape, voltage and frequency complying with current
regulations.
Keep the connection and extension cables away from
dangerous moving parts to avoid damaging them.
Only use splash proof extension cables approved for
outdoor purposes. The stranded wire cross-sectional area
of the extension cable must be at least 1.5 mm² for cables
up to 25 m and 2.5 mm² for cables above 25 m.
Make sure the machine is switched off before plugging in.
The unit must be supplied via a residual current device
SPECIFIED CONDITIONS OF USE
The shredder is designed exclusively for shredding
fibrous or woody garden waste such as hedge and tree
trimmings, branches, bark or fir cones.
The shredder must not be filled with stones, glass, metal,
bones, plastics or material waste.
WARNING
Risk of injury
Rotating blades may lead to serious injuries by cutting
or amputating parts of the body.
• Be careful to avoid injury by the cutting tools. Careful
appliance handling reduces the risk of injury by knife.
• Do not touch any dangerous moving parts before
the machine has been disconnected from the power
supply and the moving parts have come to a complete
standstill.
• All protection covers and safety devices must be correct-
ly attached to operate the device.
• Never use the machine with a damaged cover or protec-
tive device or without cover or protective devices.
(RCD) with a rated residual current of no more than 30
mA. Operate the unit only from a socket outlet with a
protective earth contact that is fused with at least 16A.
If necessary, please consult your electricity company to
ensure that the continuous current carrying capacity of
the mains at the connection point is sufficient for connec-
ting the device.
WARNING
WARNING! Electric shock! There is a risk of an injury
caused by electric shock!
Do not use the device if the cable or plug is damaged or
worn.
If the cable is damaged during use, it must be discon-
nected from the mains supply immediately. Do not touch
the cable until it has been disconnected from the mains.
Do not connect a damaged cable to the power supply
and do not touch a damaged cable before disconnecting
it from the power supply, as damaged cables can lead to
contact with active parts.
Do not use this product in any other way as stated for
normal use. Not observing general regulations in force
and instructions from this manual does not make the
manufacturer liable for damages.
Please note that permissible uses for the tool could be
limited by national regulations. It is necessary to comply
with the regulations applicable in the country where the
truck is used.
Do not use the device near flammable liquids or gases.
Risk of fire and explosion in case of short circuit.
EN
ENGLISH
15

Publicidad

loading