Publicidad
Idiomas disponibles
Idiomas disponibles
Before use
This Wet/Dry shaver can be used for
wet shaving with shaving lather or for
dry shaving. You can use this water-
tight shaver in the shower and clean
it in water. Treat yourself to wet lather
shaves for at least three weeks and
notice the difference. Your Panasonic
WET/DRY
shaver requires a little
time to get used to because your skin
and beard need about a month to
adjust to any new shaving method.
Parts identification
(see fig. 1)
Protective cap
System outer foil
System outer foil release but-
tons
Foil frame
Inner blades
Foil frame release buttons
On/Off switch
Switch lock button
Battery cover
Battery cover release dial
Cleaning brush
Travel pouch
©@©©@@@@@
000
Replacing batteries
Before replacing the battery, wipe the
shaver free of moisture to prevent the
inside from getting wet.
1. Turn the battery cover release dial
and remove the battery cover.
(Turn the dial in the counter clock-
wise direction and match the
mark to the open
position.)
(Fig.2A)
2. Insert the two CR123A lithium
batteries
as
shown
in the
figure.Make sure that their polar-
ity matches that indicated inside
battery compartment (Fig.2B). If
the batteries are not inserted
properly, the shaver will not op-
erate, Do not mix a new battery
with an old one. Always replace
with 2 new fresh batteries.
3. Replace the battery cover with
the dial mark at open. Check for
proper sealing of the water-proof-
ing ring.
4. Alter replacing the battery cover
to the main unit, turn the dial mark
to close. (Fig. 2C)
For a better shave
Put a thin layer of shaving
foam on
your face which works as lubricator.
Shaving foam is the most suitable
among many other shaving aids (gel,
soap, Cream, etc). Do not put a thick
layer of shaving foam as it may af-
fect shaver's performance. lí the
shaving head is clogged with foam,
simply rinse it under running water.
Depress the switch lock button and
slide the On/Off switch upward to turn
the shaver on. Hold the shaver at a
right angle (90°) to your skin (see fig.
3). Start out shaving by applying gen-
tle pressure to your face. Stretch your
skin with your free hand and move
the shaver back and forth in the di-
rection of your beard. You may gen-
tly increase the amount of pressure
as your skin becomes accustomed
to this shaver. Applying excessive
pressure does not provide a closer
shave.
Publicidad
