Parkside Performance PSSAP 20 Li C4 Guía Rápida página 32

NOTE
This instruction manual contains information and
u
suggestions for several saw blades and their uses.
The saw blades depicted are not necessarily included
in the shipment, but are meant to indicate additional
possibilities for using this product.
Suitable battery packs and chargers
Battery pack:
Parkside X 20 V Team
Charger:
Parkside X 20 V Team
˜ Operation
˜ Attaching/removing the battery
pack
Removing the battery pack: Press the battery pack
release button . Remove the battery pack
[ ]
Attaching the battery pack: Align the battery
pack to the handle and slide it into it. Ensure it clicks
[ 8 ]
noticeably in place.
NOTE
If the battery pack
u 8 ] [
the on/off switch is pressed for the first time, the
6 ] [
connection status LED
[
˜ Checking the battery pack charging
level
(Fig. B)
Check battery pack charge level: Press the
button . The charging level LEDs
[ ]
LED
[ ]
Red/orange/green
Red/orange
Red
˜ Charging the battery pack
(Fig. C)
NOTE
The battery pack may be charged at any time
u [ 8 ]
without reducing the life.
Interrupting the charging process does not damage the
u
battery pack .
[ 8 ]
Charge the battery pack
medium or low charging level.
The charging control LEDs (green
the status of the charger
32 GB/IE
(Fig. D).
[ 8 ]
is inserted into the product and
flashes 3x.
]
light up:
[ ]
Charging level
Maximum
Medium
Low
before operation when it is at
8 ] [
and red ) indicate
[ ] [ ]
and the battery pack :
[ ] 8 ] [
LED
Red LED lights up
Green LED lights up
Green and red LED flashing
Red LED flashing
Green LED lights up (without
battery pack)
Insert the battery pack
[ 8 ]
Connect the power cord with power plug
charger to the socket.
[ ]
When the battery pack
8 ] [
battery pack from the charger
power cord with power plug
socket.
˜ Adjusting the base plate
(Fig. E)
m
WARNING!
Always switch the product off, remove the battery
pack and let the product cool down before
[ 8 ]
making any adjustments!
m
CAUTION! RISK OF INJURY!
Saw blades can be sharp and become hot during
use. Always wear protective gloves when handling
saw blades.
m
CAUTION! RISK OF INJURY!
Remove the saw blade from the product before
u
adjusting the base plate
the saw blade").
Do not use the product without having inserted the base
u
plate .
4 ] [
To adapt to the workpiece, the base plate
and swivelled to different positions.
Unlock the base plate
[ 4 ]
counter-clockwise direction.
Adjust the desired position of the base plate
it in or pulling it out.
Lock the base plate : Turn the locking lever
4 ] [
clockwise direction.
˜ Inserting/removing the saw blade
m
WARNING!
Always switch the product off, remove the battery
pack and let the product cool down before
8 ] [
making any adjustments!
Status
Battery pack charges
Battery pack fully
charged
Battery pack defective
Battery pack too cold or
too warm
Charger ready
into the charger .
[ ]
of the
[ ]
is fully charged: Remove the
. Then disconnect the
[ ]
of the charger from the
[ ]
(see "Inserting/removing
4 ] [
can be adjusted
4 ] [
: Turn the locking lever in a
[ 1 ]
by pushing
[ 4 ]
in a
1 ] [