Publicidad
Idiomas disponibles
Idiomas disponibles
Comments:
Pairing takes about 5 minutes. If no device is paired within this
time frame, the headset automatically switches to standby mode.
• If the connection fails, turn off the headset and try the connection
again. Refer to the manufacturer's manual for more information.
• If your phone has a wireless system older than version 2.1, your
headset may require an identification key. If so, type
confirm.
• After successful pairing, the headset and your mobile phone
will connect automatically when they are in proximity to one
another. The headset can save up to 8 devices. When there are
more than 8 devices, the first will be replaced.
• Each time the headset is turned on, it will pair with the last
device connected. If you want to pair another device, turn
off the wireless function of the last device connected to the
headset.
Listening to music
•
Start playback on your wireless audio device.
•
To move to the next track, press and hold the
•
To return to the previous track, press and hold the
•
To pause playback, press the --- button.
•
To return to playback, press the --- button again.
Adjusting the volume
•
To increase the volume, press briefly on the
•
To reduce the volume, press briefly on the
• A signal sounds when you have reached the maximum or
minimum level.
Incoming call detection
When a call is received or dialled, the phone pauses music
playback. The transmission of music from your mobile phone to
your headset is interrupted.
When the call ends, the phone resumes playback from the point
where it was interrupted, and streams music to your headset
again.
52
0000
and
button.
button.
button.
button.
Take a call
When there is an incoming call, a beep sounds. To take the
incoming call, press the --- button.
End a call
To end a call, press the --- button.
Reject a call
To reject an incoming call, press and hold the --- button for
approximately 2 seconds.
Make a call
Dial the telephone number on your mobile phone. You can then
talk to your caller via the microphone built into the headset.
Redial last call
To redial the last number you called, press the --- button twice,
until you hear a beep.
Activate voice command
When you are not on a call, press the
activate voice command.
Deactivate the microphone during a call
While on a call, press twice briefly on the --- button to deactivate
the microphone so that the caller cannot hear you. Press twice
again briefly on the --- button to activate the microphone.
Cancelling the Bluetooth* connection
Turn on your headset and hold down the
seconds until you hear a beep.
and
buttons briefly to
and
buttons for 5
53
Publicidad
