Publicidad
Idiomas disponibles
Idiomas disponibles
Function and Operation
MODES OF OPERATION
Choose a mode by turning the rotary knob. The light will turn on immediately when power is applied. Wait for 30
seconds to allow the sensor to warm up.
1. Test MODE (daytime and nighttime operation.)
● The light will turn on when motion is detected, and stay on as long as the motion continues. The light will turn to
low-level brightness (30%) after 5 seconds when motion is no longer detected.
2. Off MODE (nightime operation only)
● At dusk, the light stays off and will turn to high-level brightness (full brightness) when motion is detected, and stay
on as long as the motion continues. When the motion stops, the light will stay on for the predetermined time set
(5~180 seconds), then the light will turn off.
3. Auto MODE (nighttime operation only)
● At dusk, the light will turn on when motion is detected, and stay on as long as the motion continues. When the
motion stops, the light will remain on for the predetermined time set (5~180 seconds) and then turn to low-level
brightness (30%).
● The light will turn off automatically at dawn.
4. PC MODE (nighttime operation only)
● The light will turn on automatically at dusk and turn off at dawn.
5. Manual Override MODE (nighttime operation only)
● To shift to the manual override mode, set the switch to "Auto" or
"Off" mode. Turn the wall switch "OFF" and "ON" within 3 seconds.
The light will remain on until dawn. To restore to the "Auto" or "Off"
mode, turn the wall switch "OFF" and "ON" within 3 seconds.
(See Fig.4)
● The light will last for one night only and turn off automatically at
dawn.
Note: 1. Always keep the wall switch in the "ON" position
(including the daytime).
2. Please notice the warm up time is 30 seconds, any
operations are invalid during this time.
Customization Options
Shut-off Delay
1. The Shut-off delay is the length of time that the light will stay on
after motion stops.
2. The Shut-off delay can be adjusted by using the "Time" knob when
the knob is set in"OFF" or "AUTO" mode.(See Fig.5)
3. The range of shut-off delay is 5 seconds to 3 minutes.
4. Rotate the knob clockwise for increasing the shut-off delay.
5. Rotate the knob counterclockwise for decreasing the shut-off delay.
Fig. 4
Fig. 5
Page 3 / 5
Turn wall switch OFF-ON
in 0.5~3 Seconds
Off Mode
Auto Mode
Turn wall switch OFF-ON
in 0.5~3 Seconds
(View from back of sensor lens)
Auto
Off
Test
PC
Time
Mode
Manual
Override
Sens
231012
Publicidad
