Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING ARM INSTALLATION
Before beginning, disconnect the power to the junction box. If replacing an existing fixture with more than two wire
leads, make note of where they were connected.
1.Remove both wire compartment cover bolts, then remove the compartment cover (Fig.1).
2. For safety and proper operation, your fixture must be properly grounded. With
a wire nut (C) connect the yellow and green ground wires (attached to the fixture)
with the ground wires from the junction (Fig.6) . If unfamiliar with methods of
properly grounding fixtures, consult a qualified electrician.
Using the included wire nuts, connect the white supply wire to the white
(NEUTRAL) fixture wire, and the black supply wire to the black (LIVE) fixture wire.
Tuck connections back into the mounting arm to avoid tangling.
Do not pinch the wires while installing the fixture onto the mounting arm.
3. For mounting on a standard 2 in. diameter
mounting arm*: slide the fixture mounting
base carefully over the mounting arm while
tucking the wires into it until it is fully seated
against the fixture (Fig. 7). Use the included
mounting arm crossbar (A) to secure the
light to the mounting arm by aligning the
holes (Fig. 8). Tighten both bolts down
(Fig. 9).
* Outdoor mounting arm not included.
CCT SELECTABLE
Switching Correlated Color Temperature:
1. Remove the cap. (Fig. 11)
2. Select desired color temperature before operation. (Fig. 10)
3. Replace the cap after selecting the color temperature.
For 3000K
For 4000K
Fig. 10
TROUBLESHOOTING GUIDE
Before starting work to connect the fixture, shut off power supply at the circuit breaker panel to avoid electrical shock.
Problem
Fixture does not turn on.
Light comes on during
the day.
Light cycles continuously
turn ON and OFF
(flickering lights).
Fig. 7
For 5000K
Probable Cause
1. Faulty connection.
2. Faulty switch.
3. Power is off.
1. The fixture is located in a
shaded area; the dusk-to-
dawn sensor is detecting
darkness.
1. The dusk to dawn sensor is
detecting reflected light from
glass, a painted roof, a wall
or etc.
2. Height is < 6.5 ft.
Page 3 / 4
Fig. 6
Fig. 8
Mounting
Arm Crossbar (A)
3000K 4000K 5000K
To
Tighten
Fig. 11
Solution
1. Check the wiring connections.
2. Test the switch or replace it.
3. Verify that the power is on.
1. Shine a light at the dusk-to-dawn sensor. If the security light
immediately shuts off, then the fixture is located in an area
that is too dark to allow enough light to enter the sensor.
The light will need to be relocated.
1. Change the positioning of the light head and avoid it affecting by
reflecting light.
2.
Move the light to a different location where the results are better
and away from the items/surface may cause reflection.
3.
Place a small piece of black electrical tape over half of the dusk-to-
dawn sensor.
Wire Connector (C)
Fig. 9
To
Loosen
231127
Publicidad
