Publicidad
Idiomas disponibles
Idiomas disponibles
2. Screw the pedals onto the crank arms and use the
wrench to tighten them securely.
Note: Left pedal should be tightened counter-
clockwise.
4
OPERATION
This section describes how to operate the product.
English (Original Instructions)
CAREFULLY READ AND UNDERSTAND
THE SAFETY CHAPTER AND OPERATION
INSTRUCTIONS BEFORE YOU OPERATE THE
PRODUCT.
4.1
BEFORE YOU RIDE
4.1.1 PRE-RIDE CHECKLIST
Make sure to check the condition of the product before
each ride.
Brakes
•
Ensure front and rear brakes work properly.
•
Ensure brake shoe pads are not overworn and are
correctly positioned in relation to the rims.
•
Ensure brake control cables are lubricated properly,
adjusted correctly, and are not showing any obvious
signs of wear.
•
Ensure brake control levers are tightened securely
onto the handlebar.
Steering
•
Ensure that the handlebar and stem are
appropriately adjusted and tightened to enable
safe and proper steering. Refer to INSTALL THE
HANDLEBAR.
Wheels and Tires
•
Ensure tires are inflated to within the maximum
recommended limit displayed on the tire sidewall.
•
Ensure tires have tread and no bulges or excessive
wear.
•
Ensure rims are not bent and show no obvious
wobbles or kinks.
•
Ensure all wheel nut spokes are securely tightened
and visually inspect for broken or missing pieces.
•
Check that axle nuts are tight. Refer to INSTALL
THE FRONTWHEEL.
Chain
•
Ensure chain is oiled, clean and runs smoothly.
Derailleur
•
Check that front and rear guide pulley and tension
pulley are adjusted and function properly.
•
Ensure control levers are attached securely.
•
Ensure derailleur, shift levers, and control cables are
lubricated properly.
4.1.2 CHOOSE THE RIGHT BIKE HELMET
Make sure to comply with the local laws and always
wear a helmet when riding this product. It is crucial
to wear a bicycle safety helmet that fits correctly and
is approved by the CPSC (Consumer Product Safety
Commission) to ensure the highest level of safety while
cycling.
11
WARNING
EN
Publicidad
