Palram CANOPIA GP 08 24 Manual Del Usuario página 6

EN
2400W PORTABLE SPLASH RESISTANT GREENHOUSE FAN HEATER
5. SPECIAL SAFETY REGULATIONS
5.1
Before use, please check the marking on the power cord. Depending on the power cord
type this appliance may be used in different ambient conditions.
5.2 When using electrical appliance basic precautions should always be followed including below:
5.2.1 The fan heater is not suitable for use outdoors in damp weather, in bathrooms or in other
wet or damp environments.
5.2.2 Please note that the fan heater can become very hot and should, therefore, be placed at a
safe distance from flammable objects such as furniture, curtains and similar.
5.2.3 Do not cover the fan heater.
5.2.4 The fan heater must not be located immediately below a socket outlet.
5.2.5 You can only connect the fan heater to the Palram controller supplied or directly to the
electrical socket , do not use any other automatic ON/OFF switch on this device.
5.2.6 The fan heater must not be placed in rooms where flammable liquids or gases are used or
stored.
5.2.7 If an extension cord is used, it must be as short as possible and always be fully extended.
5.2.8 You must not connect other appliances to the same mains socket as the fan heater.
5.2.9 Do not use this fan heater in the immediate surroundings of a bath, a shower or a swimming
pool.
5.2.10 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
5.2.11 Make sure heater is always under surveillance and keep children and animals away from it;
5.2.12 Do not place the appliance on moving vehicles or some where easy to be tipped over.
5.2.13 When you don't use the appliance for a long time, unplug the appliance. Don't leave the
heater for a considerable amount of time when in use. Pull the plug straight out, never
remove the plug by pulling on the cord.
5.2.14 Keep the heater far from curtain or places where the air inlet can easily be blocked.
5.2.15 The power coupler is waterproof when not in use. In order to prevent possible electric
shock or leakage current, never use the appliance with wet hand or operate the appliance
when there is water on the power cord.
5.2.16 Do not dispose of electrical appliances as unsorted municipal waste, use separate collection
facilities. Contact you local government for information regarding the collection systems
available.If electrical appliance are disposed of in landfills or dumps, hazardous substances
can leak into the groundwater and get into the food chain, damaging your health and well-
being.
5.2.17 This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
5.2.18 Children should be supervised to ensure that they do not play with the appliance.
6. USING INSTRUCTIONS
6.1
Position the fan heater so that it stands upright on a firm surface and at a safe distance
from wet environments and flammable objects.
6.2 Connect the heater to the included thermostat.
For heating adjust the heater to heat and connect it to the HEATING connector on the
thermostat, if you want to use the fan only for cooling you must connect the heater to the
COOLING connector on the thermostat.
6.3
Set the thermostat knob to the MAX and let the heater operate with full power.
6.4 The fan heater will switch on when the heating selector is set to one of the power settings.
6.5 Once the room reaches the required temperature, heating element will stop working but
fan also working. Once the temperature decreased, the heating element will be working.
The fan heater now starts and stops automatically and thus keeps the room temperature
constant.
7. CLEANING & MAINTENANCE
7.1
Before cleaning the appliance,disconnect it from the socket and let it cool down. The
enclosure is easily to get dirty, wipe it often with soft sponge. For every dirty parts, wipe
with a sponge dipped in <50°C water and mild detergent, then dry the heater enclosure
with clean cloth. Be careful not to let the water enter the appliance inner. Don't splash
water onto the heater,never use solvent like gasoline etc. to clean the heater,in order to
protect the enclosure.
7.2
Clean the cord and plug,dry and pack it in a plastic bag.
7.3
When you store the heater, let it cool down first, keep it dry. Then cover it with a plastic
bag, put in a packing box and store it in a dry, ventilated place.