Publicidad
Idiomas disponibles
Idiomas disponibles
A. RECIRCULATING (NON-VENTED
DUCTLESS)
iNSTALLATiON OVERVIEW
A1. Attach mounting plate to wall
A2. Prepare top cabinet
A3. Mount the microwave oven
Attach
the plate
to the wall
using toggle
bolts.
At least
one
wood
screw
must be used to attach
the plate
to a wall
stud.
1.
Remove the toggle
wings from the bolts.
2.
Insert the bolts into the mounting
plate
through
the hales
designated
to go into drywall
and reattach
the toggle
wings
to 3¼- onto
each bolt.
To use toggle
barfs:
Spacing for Toggles More Than Wall
._
___,._kness
i
i
Toggle
Wings
Mounting
Plate
,O
3. Place the mounting plate against the wall and insert the
toggle wings into the holes in the wall to mount the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure to line up bottom line of the Mounting plate
with Horizontal
line of "Rear wall Template" and then the
Mounting plate is properly centered under the cabinet.
CAUTION:
Be careful to avoid pinching fingers between the
back of the mounting plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall to help
tighten the bolts.
A2. Use top cabinet
template
for
preparation
of top cabinet
You need to drill holes for the top support screws and a hole
large enough for the power cord to fit through.
•
Read the instructions on the TOP CABINET TEMPLATE.
•
Tape it underneath the top cabinet.
•
Drill the holes, following
the instructions on the TOP
CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in the
cabinet bottom.
12
Publicidad
