Tunturi MG70 MASSAGE GUN PRO Manual Del Usuario página 10

English
Button Arrow down/ M
(fig. E B-2)
- Long press and hold, turn device in switching
mode when being in stand-by mode, or when
being in M2, M3, M4 functional mode.
- When short press, decrease gear when being in
M1 mode.
- When being in working mode M1 at lowest
gear (1300) setting, pressing the arrow down
button will set the massage gun in switching
mode.
- When short press, start working mode in stand
by mode.
Display function
Battery power indicator (Fig F-A)
The battery power level is a help to see your
battery charge level at all times.
Stall force indicator (Fig� F-C
The stall force indicator bars are a reference of the
force being applied on the massage gun when
being in use.
One bar set visible is light pressure, more bar sets
visible means more pressure on the massage gun.
Time indicator (Fig� F-D)
The time indicator is only visible in M2, M3 and
M4, indicating the time duration of the program
cycle, before it starts over again.
The time line is filling as a reference of completing
the cycle.
Speed gear indicator (Fig� F-E)
There are 5 speed settings available in self
adjustable mode M1, knowing:
1 1300 r/min
2 1600 r/min
3 1900 r/min
4 2200 r/min
5 2500 r/min
Working modes (Fig� F-F)
The display will show the active working mode
being M1, M2, M3 or M4.
10
Working modes
There are 4 working modes available.
M1 manual mode
In the M1 mode the speed is not controlled by the
massage gun and starts at 1300 rpm by default.
- Use up and down buttons to change speed as
you desire at any time.
M2 ascending mode
In the M2 mode the speed increases every ±5
seconds from: 1300, 1600, 1900, 2200, 2500 rpm.
- The time line helps to recognize the progress in
each cycle.
- After a full cycle the cycle starts over again.
- Up and down buttons to change speed are
disabled in this mode.
M3 descending mode
In the M3 mode the speed decreases every ±5
seconds from: 2500, 2200, 1900, 1600, 1300 rpm.
- The time line helps to recognize the progress in
each cycle.
- After a full cycle the cycle starts over again.
- Up and down buttons to change speed are
disabled in this mode.
M4 wave mode
In the M4 mode the speed first increases every
±2 seconds with 100 rpm starting at 1600, and
will decrease after reaching the programs highest
setting being 2200 rpm again with 100 rpm every
± 2 seconds.
- The time line helps to recognize the progress in
each cycle.
- After a full cycle the cycle starts over again.
- Up and down buttons to change speed are
disabled in this mode.