Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY TO ADVANTIUM
BUILT-IN SPEEDCOOK OVEN
UNDER-THE-COUNTER {UTC)
MOUNTING BRACKET INSTALLATION
NOTE:For UTC models PSB!200, PSB!20! Qnd
ZSC!20! onlg.
r_
open the occessorg drawer so gou hove access
to the top bracket.
Remove the three screws securing the top bracket.
Install the new UTCmounting bracket using the
screws removed previouslg.
['
1
r_
Close the drower and proceed with
the instollotion.
[]
B]
ASSEMBLING THE OVEN TO DRAWER
Ploce storage drawer on o surface with the front
of drawer honging over the edge of the surface.
Not placing the front edge of drawer over the edge
of the surface mog result in domoge to the drower
since the front edge of drawer hongs below the
bottom of drawer.
Ploce the oven on top of the storage drawer. Make
sure thot the bock and sides of the oven align with
the back and sides of drower.
NOTE:The bottom of the oven side flonges will sit
directlg in front of the top of the storage drawer
side flonges.
ASSEMBLING THE OVEN TO DRAWER
(cont.)
r_
Remove the front two bottom screws on eoch side
of the oven ond the top center screw on eoch side
of the storage drawer.
Place the side supports into the tabs on the drawer
and secure using the screws supplied and the
screws removed in Step C.
Side
Support
-
120v only J
r_
The oven and storage drawer assemblg is now
reodg to be installed. Return to the Advantium 120V
or 240V Built-In SpeedCook Oven Installation
Instructions to complete the installation.
Printedin
Koreo
2
Publicidad
