AND UN-014 Manual De Instrucciones página 9

8. OPERATING INSTRUCTIONS
1. Place compressor on a stable, sturdy and flat surface so that the unit can
be easily reached when you are seated.
2. Pull out the power cord from the base of the device and make sure that the
device is in the "Off" (O) position by pressing on the left side of switch.
3. Plug power cord into a wall outlet.
4. Connect one end of the nebulizer tubing into the air outlet connector.
5. Add the prescribed solution through the opening on the cup using an eye
dropper or pre-measured dose container.
The "6cc" marking on the nebulizer cup is the maximum level.
Medication cannot be filled beyond the maximum level.
6. Assemble mouthpiece and insert it into the top of the nebulizer cup. If an
aerosol mask is used, connect the bottom of the mask to the top of the
nebulizer cup.
7. Connect the tube to nebulizer air inlet connector.
8. Turn the power on to start the unit.
9. Initiate the treatment by placing the mouthpiece between the teeth. Inhale
and exhale through the mouthpiece.
10. If an aerosol mask is used, place the mask over the mouth and nose.
English 7